How to Tile – Floor Tile Made Easy
This is another of my articles on how to tile. Floors are fast becoming one of the tasks that many DIY Handyman DIY media, I can feel positive about our business. As each transaction DIY carefully before starting a plan to be. You should know exactly what procedure to follow if you try to save by themselves can ultimately cost you money call to bring your mess to fix.
I will try to show in this article as tile.Flooring should not be difficult, so here are a few simple steps.
The first thing you need to make sure surface is completely flat. If you remove the old tiles, all cement must be removed. As a stone is not flexible it can accommodate even the smallest bump or hump. Please note that it is not advisable to tile over a wooden floor. In their natural tendency to move the weight from the floor is applied, which means that every time you step on itCommissions under the tiles to move, which in turn cause the stones to move and is very likely that over time they crack.
Next to the center point of each wall about 1 cm above the floor level. At these points, tap a small nail and tie two chalk line tight between the nails on opposite walls. Snap chalk lines to take them on one at a time and let it go. They must be flush with the floor and went impression of lime on the floor.This should start with a cross of gypsum in the middle of the floor to the point where two lines cross is the center of your floor. This is where your top of the tile.
Now is a good idea to put your stone and decide carefully what you want to model to follow, after all, you look at this job for a long time to come.
Once you've decided what model to follow, from the center and use your glue. It will tileopposite directions from each other, so you see yourself in the middle of the floor will have one at your right and then a left and then on to the wall and right wall to the left. Only enough money in the hands of stick about four or six pieces at a time. If you only learn to tile, tile can take a long time and my opinion is not a valid option to use glue as sometimes she is a long time to giveresolve errors. Be sure to use the tile distance corner of each tile as the distance that each tile same from each company.
When the walls, it is likely that you have to cut tiles. Accurately measure the depth of the section you need tile and mark with a pen. Set the tiles in the car and choose the tile with a knife. September tiles and easy to be broken easily. If you cut your tile place the cut side of the tile against the wall leavingfinished side out.
Continue this process until the floor is finished. Making the importance of striking the exact center. Probably just to be sure you're right, you measure twice. Get this wrong and everything is wrong.
Once the stone has created can now make your voegbry adapt. Mix your voegbry according to package instructions and apply with a sponge float to ensure that ensure that each joint is filled.After about 45 minutes early for the tiles disappear in a circular motion to remove excess voegbry. It is likely that you have a couple of times to do. Are you satisfied with your putty Let it set for at least 24 hours.
When you learn to tile, tile is a good starting point because everything is flat before you, while a wall of tiles you have problems with belts slipping, etc. added Green and give him a chance, you satisfaction you get when they are gonelook to your boat will be worth the time and effort and money saved obviously.